Den orginale motor pulleyen på min Rega P3 begynte å slure og platetallerkenen gikk ikke ordentlig rundt. Jeg har fått ny pulley (i plast) fra Rega. En rund tapp kommer opp fra motoren og pulleyen skal tydeligvis trykkes på her. Mitt spørsmål er om det bør brukes lim ? Det er ikke noen annen festeanordning i pulleyen såvidt jeg kan se. Noen som har erfaring med dette ? Det virker egentlig som ganske spinkle greier.
|
Feste ny motor pulley på Rega Planar 3
- Trådstarter Bent J
- Startdato
Hei
Hentet fra Origin Live
Slipping pulley - The pulley is a taper fit on the shaft. If it becomes loose or falls off, simply replace it and give it a tap down using your fingers only - do not force it down or tap it with a hard object. Very occasionally the pulley can lose its "grip" on the motor shaft - this causes slipping which is easily observed as sudden speed variations especially on heavy passages of music. The easy solution to this, is to glue the pulley onto the motor spindle using fairly slow setting superglue - place a tiny drop of glue inside the PULLEY hole. Do not place glue on the spindle in case it drops down into the motor bearings. Fit the pulley onto the spindle and hold till set. If you make a mistake do not try and remove the pulley too forcefully or you can wreck the motor. Superglue is softened by heat so use a soldering iron to heat the pulley and then pull it off gently with a pair of pliers. Do not try heating the whole motor with a hot air gun as this will cause speed instability due to bearing distortion.
Hentet fra Origin Live
Slipping pulley - The pulley is a taper fit on the shaft. If it becomes loose or falls off, simply replace it and give it a tap down using your fingers only - do not force it down or tap it with a hard object. Very occasionally the pulley can lose its "grip" on the motor shaft - this causes slipping which is easily observed as sudden speed variations especially on heavy passages of music. The easy solution to this, is to glue the pulley onto the motor spindle using fairly slow setting superglue - place a tiny drop of glue inside the PULLEY hole. Do not place glue on the spindle in case it drops down into the motor bearings. Fit the pulley onto the spindle and hold till set. If you make a mistake do not try and remove the pulley too forcefully or you can wreck the motor. Superglue is softened by heat so use a soldering iron to heat the pulley and then pull it off gently with a pair of pliers. Do not try heating the whole motor with a hot air gun as this will cause speed instability due to bearing distortion.