Nylig innhold av joliv

Just let it play alone 5 more times on side A (Sony HF type I) - my ears don't notice any loss... Meanwhile I recorded in a brand new Maxell XLII-S a 3150Hz sine using direct connection from my phone. Results from Wfgui are better - tape quality counts :) . W&F still showing some higher > .01 in...

Maybe we can investigate if there was really some kind of "bad batch" of erase heads by serial number ? here's mine 2051513520 Just finished 1st run of play side A - didn't notice any treble drop - well until now.

Interesting thread... (also subscribe that forum as "joliv") will keep eyes open. What I've tested so far - recorded one of my favorites jazz singers - Karen Souza - Tape Sony HF 90 A Side no Dolby, finishing right now B side with Dolby C. Done first 3 recordings of same "Sway" track - without...

I haven't done yet any (full) recordings on it - planning to do it. I still have 1 brand new Sony HF (my preferred "normal") - and will do a recording - will let you know. One thing that I don't like is that the meters are "slower" in responding to music - inputing same source on it and on my...

Here's the link for download - no need for e-mail https://www.swisstransfer.com/d/6bb87d0d-72e3-4355-a511-2a2ed75569e0

Updating: job finished - not receiveing any answer from ebay seller, decided to try - in fact, it seems correct (though .3mm less in width) - fitted without much stretching around capstans / motor. Now, impressions - W&F improved but not as much I was expecting - stands now between .09% and...

Hello again and need your advice - received today the capstan belt from an e-bay seller and I'm puzzled - either the old one was not original (which could explain the abnormal W&F or even the noise if the belt was slipping on the capstans) or the new one is not the right one - it's shorter 7.2mm...

Ok - got it -

OK - now I am at the same step as the picture DSCF8716 (the 6th) - I just saw an hidden screw next to the 4 contact motor - but in doubt how to go to next step in photo 7 - I see there's 2 wire connections from small board to middle motor which I am afraid to broke or force... motor position in...

Thanks again for the feedback: already took out the power supply board - I suppose from the photos that the cassette tray loader was "in" for the operation. I've received a lot of those "dozens" different made in China belts (through ebay) never used them to check if they are bad or suffciently...

Thank you for your feedback. Yes, taking out the transformer/power supply should be easy. About noisy motor: I've seen this in the past on 2 Pioneers and fixed by droping a tiny drop of oil on the motor shaft (with a tiny screwdriver for example) and rotate the shaft few times - repeating with...

Hello Thank you for these photos I found: I'm about to replace the belts on a DRS-810 I acquired last week with quite noticeable Wow & Flutter, so looking for as many info as I can get as like you said it's not an easy job. Did you also disassembled the front panel ? not clear from photos. Is it...