oyvjorge
Hi-Fi freak
Vurderer dise to opp mot hverandre til en Rega RP8. Skulle tro begge passer til armen? Den ene er lav og den andre høyt utsignal. Så finnes det jo en søster til Aida som har mellomhøyt utsignal. Er på utkikk etter et noe varmere lydbilde enn Apheta 2 som jeg har nå. Men ikke for varmt. Innbiller meg at Dyn ikke er den varmeste. Noen med formeninger?
[h=2]SPECIFICATIONS XX2[/h]
AIDA
Stylus: Contact Line Nude, 0.100mm SQ
Radius of curvature: OCL (Optimized Contour Contact Line)
Cantilever: Ruby
Recommended tracking force: 10mN / 1.0 gm (high), 13mN / 1.3 gm (medium)
Effective tip mass: 0.30 mg
Compliance: 28 μm/mN (high), 22 μm/mN (medium)
Frequency response: 20-20,000 Hz ± 2.5 dB
Channel separation (stereo only): 1000 Hz >30 dB, 50-15,000 >20 dB
Channel difference: <1.0 dB (Stereo), <1.0 dB (Mono)
Output voltage (Aida): 2.12 mV
Cartridge weight: 6.8 grams
Loading (Aida): ≥ 47 kΩ
[h=2]SPECIFICATIONS XX2[/h]
- Type: Low output moving coil cartridge with Alnico magnet and Flux damper
- Output Voltage: 0.28mV (at 1KHz, 5cm/sec.)
- Channel Separation: 30 dB (at 1KHz)
- Channel balance: 1.0 dB (at 1KHz)
- Frequency response: 20 - 20,000Hz (± 1dB)
- Compliance: 10 x 10-6 cm/dyn
- Tracking force: 1.8 - 2.2 grams
- Impedance: R=6 ohms
- Recommended load resistance: > 30 ohms
- Cantilever: 6mm length 0.3 mm dia. solid boron
- Stylus: 0.14 x 0.08 mm Line contact PF
- Weight: 8.9 grams
AIDA
Stylus: Contact Line Nude, 0.100mm SQ
Radius of curvature: OCL (Optimized Contour Contact Line)
Cantilever: Ruby
Recommended tracking force: 10mN / 1.0 gm (high), 13mN / 1.3 gm (medium)
Effective tip mass: 0.30 mg
Compliance: 28 μm/mN (high), 22 μm/mN (medium)
Frequency response: 20-20,000 Hz ± 2.5 dB
Channel separation (stereo only): 1000 Hz >30 dB, 50-15,000 >20 dB
Channel difference: <1.0 dB (Stereo), <1.0 dB (Mono)
Output voltage (Aida): 2.12 mV
Cartridge weight: 6.8 grams
Loading (Aida): ≥ 47 kΩ