Her er litt fra Installers guide:
Om selve installeringen:
Using a USB Cable
Steps 1 to 6 below are only necessary when connecting to the PC a PDC that has not been
connected via USB to that PC before.
1. Connect the PDC to the PC using the USB cable.
2. Turn on the PDC, using the power switch at the back of the PDC.
3. If you have Windows XP, the PC should automatically detect the PDC and advise that there
is new USB hardware.
3a. If this doesn't happen, try turning the PDC off and on. The PC should then recognize the
new device.
4. Windows should start up a Found New Hardware Wizard, or a similar Wizard. This wizard
may ask if Windows can connect to Windows Update to search for software. If so, choose 'No,
not this time' then click Next. At the next dialog choose the option to install the software
automatically.
4a. The Wizard should be able to find the driver by itself (you don't need to use the option of
manually finding the driver). Windows may pop up a window to say that the software hasn't
passed Windows logo testing. If this happens click on the Continue Anyway button.
5. The Wizard will install the driver then ask you to click on Finish to close the Wizard.
6. Windows may pop up a brief message that new hardware has been installed.
7. Launch DEQX Calibration.
8. To change the connection type in the software from RS232 to USB, choose Tools-Options.
In the Configuration Options dialog choose the Configuration tab and select USB.
Note that when the USB cable is connected between the PDC and the PC, an RS232 cable
will not work.
The state of the link between DEQX Calibration and the PDC is indicated by the Link icon at
the right of the status bar, at the bottom of the DEQX Calibration window.
Her er fra Trouble shooting seksjonen i Installers guide:
What to do if the PC does not Detect the PDC via USB Cable
1. The PC may not detect the PDC if the firmware does not support USB. Check the firmware
installed on the PDC by connecting via RS232 and reading the firmware version number in the
bottom right quadrant of DEQXCal's IO Manager. The firmware should be 45.6 or higher. If it
is not then upgrade the firmware (See Upgrading the Firmware in the Using DEQX
Calibrated - Step by step section).
2. Sometimes the PC does not automatically detect the PDC when the PDC is first connected
via USB. Try switching the PDC off then on again slowly a few times.
3. The PC may not detect the PDC if the USB cable is longer than 3m. Try a shorter USB
cable.
4. The PC's USB port (or ports) may not be functioning properly. Does the PC detect other
USB devices when they are connected to the same USB port that the PDC was connected to?
If not then the PC is faulty.
5. Sometimes it helps to try swapping USB ports on the PC.
6. As a last resort try restarting your PC.