Hei. Jeg nylig kjøpt meg en sub og lurer på hva som er optimal justering av crossover. Har xtz 100.33 divine stativ høyttalere. Bør jeg sette frekvensen på rundt 50hz ? Jeg har ikke måle mic eller lignende , men hører selv at de går ned til 37 hz.
As touched on earlier, the 100.33s offer quite a few tuning options. The least unique of the options are standard port plugs that allow users to control bass output by making the speakers sealed, single port open, or double port open. I tested the speakers using bass sweeps generated by Room EQ Wizard (calibrated UMIK-1 microphone, 1 meter from speaker). Leaving both ports open resulted in decibel gain just prior to roll off (around 50Hz) followed by a rather sharp drop. Leaving both ports closed resulted in lower loudness around 50Hz with a much more subtle roll off, and one port open fell somewhere in between. Following some listening sessions, my preferred mode was one port open. That particular setting breathed noticeable life into the speakers' bass response while keeping it tight and snappy.
As touched on earlier, the 100.33s offer quite a few tuning options. The least unique of the options are standard port plugs that allow users to control bass output by making the speakers sealed, single port open, or double port open. I tested the speakers using bass sweeps generated by Room EQ Wizard (calibrated UMIK-1 microphone, 1 meter from speaker). Leaving both ports open resulted in decibel gain just prior to roll off (around 50Hz) followed by a rather sharp drop. Leaving both ports closed resulted in lower loudness around 50Hz with a much more subtle roll off, and one port open fell somewhere in between. Following some listening sessions, my preferred mode was one port open. That particular setting breathed noticeable life into the speakers' bass response while keeping it tight and snappy.