Dazed skrev:
Det hadde vært flott. At spillerne kan gjøre det med CD- og DVD-lyd tar jeg nesten som en selvfølge.
Det vet jeg at de kan
Men ble litt i stuss på SACD via (L)PCM nå, fra manualen til spilleren min:
PCM SACD Direct Stream Digital (DSD) data is converted into multi-channel, highresolution
PCM data. The converted PCM data is then output through HDMI or the internal
DAC (Digital to Analog Converter) for the analog audio output ports. If you use a receiver
that supports HDMI v1.1 to listen to SACD, please select this option. You may also want to
select this option if you prefer the sound quality of the DSD-to-PCM conversion.
DSD SACD DSD data is output over HDMI without any conversion. For the analog audio
outputs, DSD data is converted into analog signal directly by the internal DAC. If you use a
receiver that supports HDMI v1.2a with DSD over HDMI, or you prefer the sound quality of
straight DSD to analog, please select this option.
4. Coaxial/Optical Output: To set the output format for the coaxial/optical digital audio output for
use with Dolby Digital and DTS-compatible receivers. The options are:
LPCM Forces down-mixed 2-channel digital audio output. Choose this setting if your
receiver/amplifier only supports stereo digital (PCM) audio.
Bitstream Passes audio as compressed bitstream format to the receiver/amplifier.
Choose this setting if your receiver/amplifier is capable of decoding Dolby Digital and/or
DTS.
5. LPCM Rate Limit: To set the maximum Linear PCM output frequency for the coaxial/optical
digital output. This menu item is intended to ensure that the audio output is compatible with
equipment that cannot support high sample rates. It sets an upper limit to decide whether the
player shall down-sample audio. The player does not up-sample audio to higher sample rates.
The options are:
48K Supported by most equipment.
96K Allows a higher sampling rate and frequency response. It can result in better audio
quality. Ensure that the receiver/amplifier can support it.
192K Allows the highest sampling rate and frequency response. It can result in the best
audio quality. Ensure that the receiver/amplifier can support it.
Og senere i manualen står følgende:
Coaxial or Optical Digital Audio to Receiver
If your audio connection is as described in Method 6 on page 15 of this guide, and the A/V receiver supports
Dolby Digital and DTS decoding, the following audio format setup options are recommended:
o Secondary Audio: Off (or On if you need secondary audio)
o HDMI Audio: Off
o
SACD Output: (any SACD is not available through the
optical/coaxial output)o Coaxial Optical Output: Bitstream
o LPCM Rate Limit: 48k (or higher if supported by the receiver)
Så synest jeg det ser litt mindre lovende ut for SACD konvert til LPCM og sendt ut digitalt på optisk/coax.
