[StudioSound]

Før 32.495 kr./stk.
Nu 19.995 kr./stk.

Enclosure: Vented (front) and tuned to 37 Hz Super strong glued Pan Fiber construction 1 1/2" thick front baffle Mass loaded Internal and external resonance damping Floor standing with dynamic coupling feet Low diffraction High durability three step textured black finish standard on VSM-MM Premium high-gloss color finishes standard on VSM-MX Brass tuning rods on front and top of cabinet Hand-crafted speaker grills included Woofer: 6.5 inch paper carbon-fiber cone Cast aluminum basket Low diffraction rubber surround Large motor, rear vented Specifically manufactured for Merlin Music Systems by ScanSpeak Tweeter: 1 inch soft dome Dynaudio Esotar D330/A Crossover: Highly optimized 12 dB per octave Crossover point at 2200 Hz Both drivers wired in electrical phase Fixed output (no level controls) Impedance corrected Electronic circuit damping Proprietary ultra-low loss inductors by Hovland Hovland Aluminum foil and polypropylene capacitors Caddock Micronox® Film resistors Wired with Cardas wire Bi-wireable via Cardas "low stress" binding posts Removable outboard RC Networks EMI/RFI filtering networks Point-to-point hand wired Easily removable for upgrades/repairs Bass Augmentation Module (BAM): 5.2dB of boost at 35 Hz Subsonic bass roll-off below 27Hz Outboard power supply Optional rechargeable battery power supply Single ended (RCA) or fully balanced (XLR) models available Cardas Cross internal wiring Caddock Micronox® Film resistors Hovland Aluminum foil and polypropylene capacitors Input impedance: 40k ohms Output impedance: 100 ohms THD: < 0.005% Maximum output voltage: 9.5Vrms Power requirements: 50/60Hz 110VAC to 117VAC.

Frequency Response: 33-22 kHz +/- 2dB, 1 meter on axis

4dB down at 30Hz with BAM in circuit

36-20kHz +/- 1.75 dB, 1 meter on axis

36-20kHz +/- 1.5 dB at 10° off axis (optimum listening axis)

Acoustic phase shift: Less than 10°

Impedance: 8 ohms nominal 6.5 ohms minimum 15.6 ohms at crossover point

Sensitivity: 89 dB, 1W/1M (2.83V)

Excellent tube amplifier compatibility

Power Handling: 200 watts (program)

Maximum output 111 dB (program)

Power requirements suggested: 17 watts minimum (tube) 25 watts minimum (solid state) 200 watts maximum

Dimensions and Weight: Speakers: 8-5/8 inches wide by 10-1/2 inches deep by 42-7/8 inches high 84.5 lbs. each

BAM: 6-3/4 inches wide by 8-3/4 inches deep by 2-1/4 inches high

195 lbs. in packaging (one pair in carton with BAM)

Warranty: 10 years parts and labor Options:

Fully balanced (XLR input/output) Battery BAM. Includes a self contained, rechargeable battery power supply. Single ended/Balanced BAM unit with self contained rechargeable power supply available.